MartinLogan Ticket Spezifikationen PDF herunterladen (Seite 9)

WARNING! These instructions are written

based on commonly available IR repeaters that

mount in a

/2" diameter hole. Before beginning

this installation, please refer to the instructions

that came with your IR repeater to verify this

hole size. If your IR repeater requires a hole size

other than

/2" diameter, adjust these instruc-

tions accordingly. Before drilling the mounting

hole, a

/8" pilot hole should always be drilled

from the back regardless of the final mounting

hole diameter.

Required tools (not inc

luded):

Electric drill

/8" drill bit

/2" drill bit

1 Prepare a flat surface with a cushion and/or blanket to

protect the Passage. Place the Passage driver side down.

WARNING! Be careful to put no weight on

the tweeter globe.

2 From the rear of the speaker and at the location shown

in figure 13, use a

/8" drill bit to drill a pilot hole.

3 Turn the Passage over so that it is driver side up.

4 From the front of the speaker, use a

/2" drill bit to

widen the hole for the IR repeater.

5 Follow the instructions that come with the IR repeater to

finish installation.

INSTALLING AN IR REPEATER

Figure 13. Installing an IR repeater—location to drill hole.

Installing an IR Repeater 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

MartinLogan Ticket Spezifikationen Seite 9